Opel Vectra B

Since 1995 of release

Repair and car operation



Opel of Vektra
+ 1.1. Controls and control devices
+ 2. Maintenance service
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Systems of start, ignition
+ 7. Transmission
+ 8. Brake system
- 9. A running gear
   9.1. Introduction
   9.2. Technical characteristics
   9.3. Rotary fists
   9.4. Replacement of forward bearings of a nave
   9.5. A forward bottom frame
   9.6. A forward rack
   9.7. The stabilizer of cross-section stability of a forward suspension bracket
   9.8. The bottom lever of a forward suspension bracket
   9.9. Replacement of the bottom hinge of a forward suspension bracket
   9.10. A back nave
   9.11. A back rack
   9.12. The stabilizer of cross-section stability of a back suspension bracket
   9.13. The top lever of a back suspension bracket
   9.14. The bottom lever of a back suspension bracket
   9.15. A steering wheel
   9.16. A steering column
   9.17. An intermediate shaft of a steering column
   9.18. Replacement of protective covers of steering transfer
   9.19. Steering transfer
   + 9.20. The pump of the amplifier of a steering
   9.21. Removal of air from system of a steering with the amplifier
   9.22. A tip of steering draught
   9.23. Steering draught
   9.24. Corners of installation of wheels
+ 10. A body
+ 11. An electric equipment
+ 12. The basic malfunctions


9fd37707

9.7. The stabilizer of cross-section stability of a forward suspension bracket
THE GENERAL DATA

The forward stabilizer of cross-section stability

Removal

PERFORMANCE ORDER
1. Remove a forward bottom frame.
2. Unscrew nuts of fastening of draughts of the stabilizer of cross-section stability to a forward rack and remove draughts.
3. Unscrew bolts of fastening of clips, крепящих the stabilizer of cross-section stability to the bottom frame.
4. Remove the stabilizer of cross-section stability from the bottom frame.
5. Note an arrangement and remove rubber plugs from the stabilizer.
6. Check up the stabilizer on deterioration and mechanical damages. Special attention give to a condition of plugs of installation of the stabilizer.

Installation

Installation is made in sequence, return to removal.