Opel Vectra B

Since 1995 of release

Repair and car operation



Opel of Vektra
+ 1.1. Controls and control devices
+ 2. Maintenance service
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
- 6. Systems of start, ignition
   - 6.1. Gymnastics system
      6.1.1. Introduction
      6.1.2. Technical characteristics
      6.1.3. Accumulator check
      6.1.4. Accumulator gymnastics
      6.1.5. The accumulator
      6.1.6. The generator
   + 6.2. Start system
   + 6.3. Ignition system
   + 6.4. System of prestarting heating of diesel engines
+ 7. Transmission
+ 8. Brake system
+ 9. A running gear
+ 10. A body
+ 11. An electric equipment
+ 12. The basic malfunctions


9fd37707 частный детский сад центральный район, частные детские сады центрального района цены.

6. Systems of start, ignition

6.1. Gymnastics system

6.1.1. Introduction
THE GENERAL DATA

If the control lamp of gymnastics of the accumulator does not burn at ignition inclusion, check up connection of wires to the generator and integrity of a control lamp. If the lamp still does not burn, check up an electric chain from the generator to a lamp. If all electric chains are serviceable, means the generator is faulty and it should be replaced or repaired.

If the control lamp of gymnastics of the accumulator burns at engine work, stop the engine and check up a condition and a tension drive a generator belt, and also connection of wires to the generator.

Check of a regulator of pressure can be made as follows.

Connect the voltmeter to poles of the accumulator and start the engine.

Increase turns of the engine before stabilisation of indications of the voltmeter which should show from 12 to 13 volt, but no more than 14 volt.

Include a maximum quantity of electric consumers (a headlight, a heater of back glass, the heater fan). Thus the pressure developed by the generator with a regulator of pressure should be in limits from 13 to 14 volt.

If pressure does not correspond to demanded sizes, the worn out brushes of the generator, weak springs of brushes, a faulty regulator of pressure, the faulty diode, winding breakage статора or defective contact rings of a rotor can be a cause of defect.