Opel Vectra B

Since 1995 of release

Repair and car operation



Opel of Vektra
+ 1.1. Controls and control devices
+ 2. Maintenance service
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
- 6. Systems of start, ignition
   - 6.1. Gymnastics system
      6.1.1. Introduction
      6.1.2. Technical characteristics
      6.1.3. Accumulator check
      6.1.4. Accumulator gymnastics
      6.1.5. The accumulator
      6.1.6. The generator
   + 6.2. Start system
   + 6.3. Ignition system
   + 6.4. System of prestarting heating of diesel engines
+ 7. Transmission
+ 8. Brake system
+ 9. A running gear
+ 10. A body
+ 11. An electric equipment
+ 12. The basic malfunctions



6.1.3. Accumulator check
THE GENERAL DATA

In the accumulator it is necessary to make check of density of electrolit each 3 months to define loading ability of the accumulator.

Check is made плотномером. At definition of density of electrolit it is necessary to consider accumulator temperature. At electrolit temperature more low 15 ° With on everyone 10 ° From less this temperature from the measured density subtract value 0.007. For everyone 10 ° With from above 15 ° With add 0.007.

The electrolit density in the accumulator should be in following limits:

Temperature
Above 25 ° With
More low 25 ° With
Full gymnastics
1.210 – 1.230
1.270 – 1.290
Gymnastics on 70 %
1.170 – 1.190
1.230 – 1.250
The discharged
1.050 – 1.070
1.110 – 1.130

Electrolit density measure in everyone bank. The difference in density 0.04 or more between two any banks specifies in loss of electrolit or сульфатацию plates.

If the electrolit density between two any banks differs more than on 0.04 the accumulator is subject to replacement. If below demanded, but identical in all banks, the accumulator it is necessary to charge density of electrolit.

In case of use of the unattended accumulator the accumulator condition can be checked up only the voltmeter. In accumulators with the built in indicator of degree заряженности the accumulator condition is defined on colour of the indicator. Green colour of the indicator corresponds to full gymnastics of the accumulator. Black colour of the indicator specifies in necessity of gymnastics of the accumulator. Dark blue colour of the indicator testifies to low level of electrolit in the accumulator.