Opel Vectra B

Since 1995 of release

Repair and car operation



Opel of Vektra
+ 1.1. Controls and control devices
+ 2. Maintenance service
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Systems of start, ignition
+ 7. Transmission
+ 8. Brake system
- 9. A running gear
   9.1. Introduction
   9.2. Technical characteristics
   9.3. Rotary fists
   9.4. Replacement of forward bearings of a nave
   9.5. A forward bottom frame
   9.6. A forward rack
   9.7. The stabilizer of cross-section stability of a forward suspension bracket
   9.8. The bottom lever of a forward suspension bracket
   9.9. Replacement of the bottom hinge of a forward suspension bracket
   9.10. A back nave
   9.11. A back rack
   9.12. The stabilizer of cross-section stability of a back suspension bracket
   9.13. The top lever of a back suspension bracket
   9.14. The bottom lever of a back suspension bracket
   9.15. A steering wheel
   9.16. A steering column
   9.17. An intermediate shaft of a steering column
   9.18. Replacement of protective covers of steering transfer
   9.19. Steering transfer
   + 9.20. The pump of the amplifier of a steering
   9.21. Removal of air from system of a steering with the amplifier
   9.22. A tip of steering draught
   9.23. Steering draught
   9.24. Corners of installation of wheels
+ 10. A body
+ 11. An electric equipment
+ 12. The basic malfunctions



9.22. A tip of steering draught
THE GENERAL DATA

Removal by a wire brush of a rust and dirt from a tip of steering draught

Removal

PERFORMANCE ORDER
1. Lift a forward part of the car and establish on supports. Remove a corresponding wheel.
2. Fix steering draught and unscrew a counternut of steering draught on a turn quarter. Do not move a counternut from this position as it will serve as a reference point at installation of a new tip of steering draught.
3. Unscrew a nut of fastening of the spherical hinge of a tip of steering draught.
4. Using a stripper, take the spherical hinge of a tip of steering draught from a rotary fist.
5. Unscrew a tip of steering draught from steering draught, having counted exact number of turns of a tip of steering draught. The right tip of steering draught is designated by letter R and has the right carving, and the left tip is designated by letter L and has the left carving.

Installation

PERFORMANCE ORDER
1. Screw up a tip of steering draught in steering draught on the same number of turns, as at removal. Thus the counternut of a tip of steering draught should be established on a quarter of a turn from steering draught.
2. Establish the spherical hinge of a tip of steering draught in a rotary fist and fix a nut.
3. Tighten a counternut of fastening of a tip of steering draught.
4. Establish a wheel and lower the car.
5. Check up corners of installation of forward wheels.