Opel Vectra B

Since 1995 of release

Repair and car operation

Opel of Vektra
+ 1.1. Controls and control devices
+ 2. Maintenance service
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Systems of start, ignition
+ 7. Transmission
+ 8. Brake system
- 9. A running gear
   9.1. Introduction
   9.2. Technical characteristics
   9.3. Rotary fists
   9.4. Replacement of forward bearings of a nave
   9.5. A forward bottom frame
   9.6. A forward rack
   9.7. The stabilizer of cross-section stability of a forward suspension bracket
   9.8. The bottom lever of a forward suspension bracket
   9.9. Replacement of the bottom hinge of a forward suspension bracket
   9.10. A back nave
   9.11. A back rack
   9.12. The stabilizer of cross-section stability of a back suspension bracket
   9.13. The top lever of a back suspension bracket
   9.14. The bottom lever of a back suspension bracket
   9.15. A steering wheel
   9.16. A steering column
   9.17. An intermediate shaft of a steering column
   9.18. Replacement of protective covers of steering transfer
   9.19. Steering transfer
   + 9.20. The pump of the amplifier of a steering
   9.21. Removal of air from system of a steering with the amplifier
   9.22. A tip of steering draught
   9.23. Steering draught
   9.24. Corners of installation of wheels
+ 10. A body
+ 11. An electric equipment
+ 12. The basic malfunctions

9.16. A steering column
Removal

PERFORMANCE ORDER

1. Remove a steering wheel.

2. Remove casings of a steering column for what unscrew an inclined control lever.

3. Unscrew two screws from a forward part of a casing.

4. Unscrew three screws from the bottom part of a casing.

5. Remove the top casing of a steering column.

6. Remove the bottom casing of a steering column.

7. Remove the index of positions of a key in the ignition lock.

8. Remove switches of turns and screen wipers.

9. Remove the ignition lock.

10. Remove the bottom furnish of the panel of devices from outside the driver, then remove the air channel connecting the distributor of air with a heater.

11. In a niche for feet of the driver unscrew screws and remove furnish of salon for access to скобе supports of a steering column. Unscrew the bottom bolt and the top nuts and remove скобу supports.

12. Note position of an intermediate shaft concerning a steering column. Unscrew tightening a bolt and remove an intermediate shaft from grooves on the bottom part of a steering shaft.

13. Unscrew bolts of the top fastening of a steering column and take a steering column from the car.

Installation

PERFORMANCE ORDER

1. Establish a steering column and half screw in bolts of fastening of a steering column.

2. Check up correctness of installation of a steering column and definitively tighten fastening bolts.

3. Establish an intermediate shaft on шлицы the bases of a steering shaft. Put on a carving of a tightening bolt the means interfering unscrewing, and screw up tightening a bolt.

4. Establish скобу supports of a steering column and freely screw nuts. On a bolt carving put the means interfering unscrewing, and fix a bolt скобу supports of a steering column. Definitively tighten fastening nuts скобы supports of a steering column.

5. Establish into place an air line and salon furnish in a niche for feet of the driver.

6. Will put the ignition lock.

7. Establish switches of turns and screen wipers.

8. Establish casings of a steering column.

9. Establish a steering wheel.