Opel Vectra B

Since 1995 of release

Repair and car operation

Opel of Vektra
+ 1.1. Controls and control devices
+ 2. Maintenance service
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Systems of start, ignition
+ 7. Transmission
+ 8. Brake system
- 9. A running gear
   9.1. Introduction
   9.2. Technical characteristics
   9.3. Rotary fists
   9.4. Replacement of forward bearings of a nave
   9.5. A forward bottom frame
   9.6. A forward rack
   9.7. The stabilizer of cross-section stability of a forward suspension bracket
   9.8. The bottom lever of a forward suspension bracket
   9.9. Replacement of the bottom hinge of a forward suspension bracket
   9.10. A back nave
   9.11. A back rack
   9.12. The stabilizer of cross-section stability of a back suspension bracket
   9.13. The top lever of a back suspension bracket
   9.14. The bottom lever of a back suspension bracket
   9.15. A steering wheel
   9.16. A steering column
   9.17. An intermediate shaft of a steering column
   9.18. Replacement of protective covers of steering transfer
   9.19. Steering transfer
   + 9.20. The pump of the amplifier of a steering
   9.21. Removal of air from system of a steering with the amplifier
   9.22. A tip of steering draught
   9.23. Steering draught
   9.24. Corners of installation of wheels
+ 10. A body
+ 11. An electric equipment
+ 12. The basic malfunctions

9.23. Steering draught
Removal

PERFORMANCE ORDER

1. Remove steering transfer.

2. Remove a corresponding tip of steering draught.

3. Measure distance from a counternut of a tip of steering draught till the end of steering draught, then unscrew a counternut.

4. Loosen the collars also remove a protective cover of steering transfer.

5. Unscrew the internal spherical hinge of steering draught from gear рейки and remove steering draught.

Installation

PERFORMANCE ORDER

1. Screw up the spherical hinge in gear рейку the demanded moment.

2. Establish a protective cover of the steering mechanism on it картере and steering draught and fix its collars.

3. Screw a counternut in position in which it was before removal.

4. Establish a tip of steering draught.

5. Establish steering transfer.

6. Check up and, if necessary, adjust corners of installation of forward wheels.