Opel Vectra B

Since 1995 of release

Repair and car operation

Opel of Vektra
+ 1.1. Controls and control devices
+ 2. Maintenance service
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Systems of start, ignition
+ 7. Transmission
+ 8. Brake system
- 9. A running gear
   9.1. Introduction
   9.2. Technical characteristics
   9.3. Rotary fists
   9.4. Replacement of forward bearings of a nave
   9.5. A forward bottom frame
   9.6. A forward rack
   9.7. The stabilizer of cross-section stability of a forward suspension bracket
   9.8. The bottom lever of a forward suspension bracket
   9.9. Replacement of the bottom hinge of a forward suspension bracket
   9.10. A back nave
   9.11. A back rack
   9.12. The stabilizer of cross-section stability of a back suspension bracket
   9.13. The top lever of a back suspension bracket
   9.14. The bottom lever of a back suspension bracket
   9.15. A steering wheel
   9.16. A steering column
   9.17. An intermediate shaft of a steering column
   9.18. Replacement of protective covers of steering transfer
   9.19. Steering transfer
   + 9.20. The pump of the amplifier of a steering
   9.21. Removal of air from system of a steering with the amplifier
   9.22. A tip of steering draught
   9.23. Steering draught
   9.24. Corners of installation of wheels
+ 10. A body
+ 11. An electric equipment
+ 12. The basic malfunctions

9.19. Steering transfer
Removal

PERFORMANCE ORDER

1. Establish forward wheels for movement directly forward.

2. Remove a forward bottom frame.

3. Unscrew a fastening bolt to the bottom frame.

4. Note position of clips of fastening of steering transfer (arrow), unscrew bolts and remove clips.

5. Remove steering transfer from the bottom frame.

6. Remove rubber pillows from steering transfer, marking their arrangement.

10. The bottom bolts of fastening картера couplings to the block of cylinders.

Installation

PERFORMANCE ORDER

1. Establish rubber pillows on steering transfer.

2. Establish clips of fastening of steering transfer and fix their bolts.

3. Establish a back support of the power unit and fix bolts to the bottom frame.

4. Establish a forward bottom frame.

5. Check up and, if necessary, adjust corners of installation of forward wheels.