Opel Vectra B

Since 1995 of release

Repair and car operation



Opel of Vektra
+ 1.1. Controls and control devices
+ 2. Maintenance service
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Systems of start, ignition
+ 7. Transmission
+ 8. Brake system
- 9. A running gear
   9.1. Introduction
   9.2. Technical characteristics
   9.3. Rotary fists
   9.4. Replacement of forward bearings of a nave
   9.5. A forward bottom frame
   9.6. A forward rack
   9.7. The stabilizer of cross-section stability of a forward suspension bracket
   9.8. The bottom lever of a forward suspension bracket
   9.9. Replacement of the bottom hinge of a forward suspension bracket
   9.10. A back nave
   9.11. A back rack
   9.12. The stabilizer of cross-section stability of a back suspension bracket
   9.13. The top lever of a back suspension bracket
   9.14. The bottom lever of a back suspension bracket
   9.15. A steering wheel
   9.16. A steering column
   9.17. An intermediate shaft of a steering column
   9.18. Replacement of protective covers of steering transfer
   9.19. Steering transfer
   + 9.20. The pump of the amplifier of a steering
   9.21. Removal of air from system of a steering with the amplifier
   9.22. A tip of steering draught
   9.23. Steering draught
   9.24. Corners of installation of wheels
+ 10. A body
+ 11. An electric equipment
+ 12. The basic malfunctions


9fd37707

9.4. Replacement of forward bearings of a nave
PERFORMANCE ORDER
1. Remove a rotary fist.
2. For removal of a nave from a rotary fist use a press and tubular оправку the corresponding diameter.
3. Establish a rotary fist an inside upwards and, using metal оправку, choose a nave from nave bearings.
4. Using a stripper, remove an internal ring of the bearing from a nave.
5. Remove a lock ring of fastening of the bearing from the interior of a rotary fist.
6. If necessary establish an internal ring of the bearing back and, опирая an internal part of a rotary fist on supports and using tubular оправку, squeeze out the bearing from a rotary fist.
7. Clear a nave and a rotary fist of a dirt, and greasings.
8. Reliably fix a rotary fist on supports and establish on it the bearing. Bearing installation make with use tubular оправки which should press on an external ring of the bearing.
9. Fix the bearing a new lock ring which should be established in flutes in a rotary fist.
10. Запрессуйте a nave in the bearing. Thus use tubular оправку which presses on an internal ring of the bearing.
11. Establish a rotary fist together with a nave on the car.