Opel Vectra B

Since 1995 of release

Repair and car operation


Opel of Vektra
+ 1.1. Controls and control devices
+ 2. Maintenance service
- 3. Engines
   + 3.1. Repair of engine SOCH established in the car
   + 3.2. Repair of engine DOSH established in the car
   - 3.3. Repair of the diesel engine of 1,7 l established in the car
      3.3.1. Introduction
      3.3.2. Technical characteristics
      3.3.3. Check of pressure of compression
      3.3.4. The top dead point (ВМТ) the piston of the first cylinder
      3.3.5. A cover of a head of the block of cylinders
      3.3.6. A pulley of a cranked shaft
      3.3.7. Casings of a gear belt
      3.3.8. Replacement of a gear belt
      3.3.9. The mechanism of a tension of a gear belt and pulleys
      3.3.10. Replacement of a sealing ring of a cam-shaft
      3.3.11. Check and adjustment of backlashes of valves
      3.3.12. A cam-shaft and pushers
      3.3.13. A head of the block of cylinders
      3.3.14. The oil pallet
      3.3.15. The oil pump
      3.3.16. An oil radiator
      3.3.17. A flywheel
      3.3.18. Replacement of sealing rings of a cranked shaft
      3.3.19. Replacement of support of the power unit
   + 3.4. Repair of the diesel engine of 2,0 l established in the car
   + 3.5. Major repairs of engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Systems of start, ignition
+ 7. Transmission
+ 8. Brake system
+ 9. A running gear
+ 10. A body
+ 11. An electric equipment
+ 12. The basic malfunctions



3.3.14. The oil pallet

Removal
PERFORMANCE ORDER
1. Remove a wire of weight from the accumulator.
2. Lift a forward part of the car and fix on supports.
3. Merge engine oil from the engine. Establish a new washer on маслосливную a stopper and screw up a stopper in the oil pallet.
4. Unscrew bolts and remove the bottom part of the oil pallet.
5. To remove a body of the oil pallet, remove a forward exhaust pipe.
6. Unscrew bolts and remove the bottom protective plate of a flywheel.
7. Gradually unscrew bolts of fastening of a body of the oil pallet to a cover of the pump and the block of cylinders of the engine. Take a body of the oil pallet from under the car.
8. Unscrew bolts and remove маслоприемную a pipe with the mesh filter.

Installation

PERFORMANCE ORDER
1. Clear all traces of a dirt and oil from interfaced surfaces of the oil pallet and the block of cylinders.
2. Establish a new sealing ring on a pipe маслоприемника and establish a pipe маслоприемника on the engine.
3. Check up that interfaced surfaces of the main block of the oil pallet and the block of cylinders pure and dry and apply a thin film hermetic on the top part of the main oil pallet.
4. Establish the main block of the oil pallet on the block of cylinders and fix bolts. A tightening of bolts make from the centre in diagonal sequence.
5. Establish a protective plate of a flywheel.
6. Establish a forward exhaust pipe.
7. Check up that interfaced surfaces of the oil pallet and the bottom oil pallet pure and dry. Apply a thin film hermetic on an interfaced surface of the bottom oil pallet. Establish the bottom oil pallet and fix bolts.
8. Lower the car and fill in in the engine engine oil.