Opel Vectra B

Since 1995 of release

Repair and car operation



Opel of Vektra
+ 1.1. Controls and control devices
+ 2. Maintenance service
- 3. Engines
   + 3.1. Repair of engine SOCH established in the car
   + 3.2. Repair of engine DOSH established in the car
   - 3.3. Repair of the diesel engine of 1,7 l established in the car
      3.3.1. Introduction
      3.3.2. Technical characteristics
      3.3.3. Check of pressure of compression
      3.3.4. The top dead point (ВМТ) the piston of the first cylinder
      3.3.5. A cover of a head of the block of cylinders
      3.3.6. A pulley of a cranked shaft
      3.3.7. Casings of a gear belt
      3.3.8. Replacement of a gear belt
      3.3.9. The mechanism of a tension of a gear belt and pulleys
      3.3.10. Replacement of a sealing ring of a cam-shaft
      3.3.11. Check and adjustment of backlashes of valves
      3.3.12. A cam-shaft and pushers
      3.3.13. A head of the block of cylinders
      3.3.14. The oil pallet
      3.3.15. The oil pump
      3.3.16. An oil radiator
      3.3.17. A flywheel
      3.3.18. Replacement of sealing rings of a cranked shaft
      3.3.19. Replacement of support of the power unit
   + 3.4. Repair of the diesel engine of 2,0 l established in the car
   + 3.5. Major repairs of engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Systems of start, ignition
+ 7. Transmission
+ 8. Brake system
+ 9. A running gear
+ 10. A body
+ 11. An electric equipment
+ 12. The basic malfunctions



3.3.10. Replacement of a sealing ring of a cam-shaft
THE GENERAL DATA

Arrangement of bolts of fastening of a back casing of a gear belt to a head of the block of cylinders


PERFORMANCE ORDER
1. Remove a camshaft pulley.
2. Unscrew bolts of fastening of a back casing of a gear belt of a head of the block of cylinders and move a casing of a gear belt as it is possible further from a head. For the best access to an oil sealing ring of a camshaft completely remove a back casing of a gear belt.
3. Drill two small apertures in end faces of a sealing ring. Screw in two self-cutting screws and flat-nose pliers for heads of screws extend a sealing ring from a nest.
4. Clear a nest of a sealing ring and a condensed surface of a camshaft.
5. Grease a new sealing ring with pure engine oil and, using tubular оправку, establish it into place.
6. Screw in bolts of fastening of the top part of a back casing of a gear belt to a head of the block of cylinders.
7. Establish a camshaft pulley.