Opel Vectra B

Since 1995 of release

Repair and car operation



Opel of Vektra
+ 1.1. Controls and control devices
+ 2. Maintenance service
- 3. Engines
   + 3.1. Repair of engine SOCH established in the car
   + 3.2. Repair of engine DOSH established in the car
   + 3.3. Repair of the diesel engine of 1,7 l established in the car
   + 3.4. Repair of the diesel engine of 2,0 l established in the car
   - 3.5. Major repairs of engines
      3.5.1. Introduction
      + 3.5.2. Technical characteristics
      3.5.3. Removal and installation of the petrol engine together with a transmission
      3.5.4. Removal and installation of the diesel engine together with a transmission
      3.5.5. Engine repair
      3.5.6. Dismantling of a head of the block of cylinders
      3.5.7. Clearing and survey of a head of the block of cylinders
      3.5.8. Assemblage of a head of the block of cylinders
      3.5.9. Removal of pistons from rods
      3.5.10. Removal of a cranked shaft
      3.5.11. The block of cylinders of the engine
      3.5.12. Pistons and rods
      3.5.13. A cranked shaft
      3.5.14. Survey radical and шатунных bearings
      3.5.15. Engine balance of assembly at major repairs
      3.5.16. Installation of piston rings
      3.5.17. A choice of bearings
      3.5.18. Installation of a cranked shaft
      3.5.19. Pistons and rods, check of working backlashes шатунных bearings
      3.5.20. Check of a working backlash of the bearing of the bottom head of a rod
      3.5.21. Installation of pistons with rods
      3.5.22. Start of the engine after major repairs
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Systems of start, ignition
+ 7. Transmission
+ 8. Brake system
+ 9. A running gear
+ 10. A body
+ 11. An electric equipment
+ 12. The basic malfunctions


9fd37707

3.5.8. Assemblage of a head of the block of cylinders
PERFORMANCE ORDER
1. Grease cores of valves with engine oil and insert them on the places. The valve establish on those places where they have been ground in.
2. Establish a spring nest.
3. Establish the thin-walled protective plug on a valve core.
4. For installation маслоотражателных caps use special metal оправку.
5. Establish клапанную a spring and a spring plate.
6. The special adaptation compress клапанную a spring and establish crackers in dredging of a core of the valve and grease them. Remove the adaptation for spring compression. Repeat this operation on other valves.
7. With a hammer through wooden брусок knock on an end face of a core of the valve that all elements of the valve were accurately established on the places.
8. On engine SOCH of 1,6 l establish hydraulic pushers, Pads axial pressure and levers
9. On all petrol engines DOCH establish a head on the block of cylinders of the engine and establish in a head pushers and camshafts.
10. On diesel engines of 1,7 l establish a head on the block of cylinders of the engine and establish in a head pushers, adjusting linings and a camshaft. Establish fuel atomizers and candles накаливания.
11. On diesel engines of 2,0 l establish a head on the block of cylinders and establish hydraulic pushers, levers and a camshaft.