Opel Vectra B

Since 1995 of release

Repair and car operation



Opel of Vektra
+ 1.1. Controls and control devices
+ 2. Maintenance service
- 3. Engines
   + 3.1. Repair of engine SOCH established in the car
   + 3.2. Repair of engine DOSH established in the car
   + 3.3. Repair of the diesel engine of 1,7 l established in the car
   + 3.4. Repair of the diesel engine of 2,0 l established in the car
   - 3.5. Major repairs of engines
      3.5.1. Introduction
      + 3.5.2. Technical characteristics
      3.5.3. Removal and installation of the petrol engine together with a transmission
      3.5.4. Removal and installation of the diesel engine together with a transmission
      3.5.5. Engine repair
      3.5.6. Dismantling of a head of the block of cylinders
      3.5.7. Clearing and survey of a head of the block of cylinders
      3.5.8. Assemblage of a head of the block of cylinders
      3.5.9. Removal of pistons from rods
      3.5.10. Removal of a cranked shaft
      3.5.11. The block of cylinders of the engine
      3.5.12. Pistons and rods
      3.5.13. A cranked shaft
      3.5.14. Survey radical and шатунных bearings
      3.5.15. Engine balance of assembly at major repairs
      3.5.16. Installation of piston rings
      3.5.17. A choice of bearings
      3.5.18. Installation of a cranked shaft
      3.5.19. Pistons and rods, check of working backlashes шатунных bearings
      3.5.20. Check of a working backlash of the bearing of the bottom head of a rod
      3.5.21. Installation of pistons with rods
      3.5.22. Start of the engine after major repairs
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Systems of start, ignition
+ 7. Transmission
+ 8. Brake system
+ 9. A running gear
+ 10. A body
+ 11. An electric equipment
+ 12. The basic malfunctions


9fd37707

3.5.5. Engine repair
THE GENERAL DATA

It is the most convenient to make works on the engine if it is established on a special bed.

Before repair of the engine it is necessary to remove from it:

– Inlet and final collectors;
– An arm of the compressor of the conditioner of air, the pump of strengthening of a steering and the generator;
– The pump of system of cooling;
– Elements of fuel system;
– A plait of wires and all electric switches, and gauges;
– The oil filter;
– A flywheel.

If it is necessary to make only repair of the block of cylinders, a cranked shaft, pistons and rods, it is necessary to remove a head of the block of cylinders, the oil pallet, the oil pump and a gear belt of a drive or a chain.

In need of carrying out of full major repairs it is necessary to remove from the engine:

– Inlet and final collectors;
– A gear belt of a drive, pulleys and the tension mechanism (except the diesel engine 2,0);
– A head of the block of cylinders;
– A flywheel;
– The oil pallet;
– The oil pump;
– Chains and asterisks (the diesel engine 2,0);
– Pistons with rods;
– A cranked shaft.