Opel Vectra B

Since 1995 of release

Repair and car operation



Opel of Vektra
+ 1.1. Controls and control devices
+ 2. Maintenance service
- 3. Engines
   + 3.1. Repair of engine SOCH established in the car
   + 3.2. Repair of engine DOSH established in the car
   + 3.3. Repair of the diesel engine of 1,7 l established in the car
   + 3.4. Repair of the diesel engine of 2,0 l established in the car
   - 3.5. Major repairs of engines
      3.5.1. Introduction
      + 3.5.2. Technical characteristics
      3.5.3. Removal and installation of the petrol engine together with a transmission
      3.5.4. Removal and installation of the diesel engine together with a transmission
      3.5.5. Engine repair
      3.5.6. Dismantling of a head of the block of cylinders
      3.5.7. Clearing and survey of a head of the block of cylinders
      3.5.8. Assemblage of a head of the block of cylinders
      3.5.9. Removal of pistons from rods
      3.5.10. Removal of a cranked shaft
      3.5.11. The block of cylinders of the engine
      3.5.12. Pistons and rods
      3.5.13. A cranked shaft
      3.5.14. Survey radical and шатунных bearings
      3.5.15. Engine balance of assembly at major repairs
      3.5.16. Installation of piston rings
      3.5.17. A choice of bearings
      3.5.18. Installation of a cranked shaft
      3.5.19. Pistons and rods, check of working backlashes шатунных bearings
      3.5.20. Check of a working backlash of the bearing of the bottom head of a rod
      3.5.21. Installation of pistons with rods
      3.5.22. Start of the engine after major repairs
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Systems of start, ignition
+ 7. Transmission
+ 8. Brake system
+ 9. A running gear
+ 10. A body
+ 11. An electric equipment
+ 12. The basic malfunctions



3.5.19. Pistons and rods, check of working backlashes шатунных bearings
THE GENERAL DATA

Arrangement of a label of identification for definition of apertures of the bottom head of a rod on the diesel engine of 1,7 l

The diesel engine of 1,7 l

To selection of a working backlash of the bearing of the bottom head of a rod apply three various loose leaves. Loose leaves are designated by a colour label at an end face of each loose leaf which thickness increases depending on colour in a following order: brown, black and dark blue. Bearings are delivered only the standard sizes.

If it is necessary to make replacement of bearings, make record of the identification label put on a lateral surface of each rod. Labels are used to choose the demanded size of the loose leaf of the bearing.
The loose leaf
Marks
I
Dark blue
II
The black
III
The brown

Other engines

On other engines are applied as standard loose leaves of bearings, and надразмерные, after repolishing of a cranked shaft. The demanded size of the loose leaf can be defined after measurement of a neck of a cranked shaft.