Opel Vectra B

Since 1995 of release

Repair and car operation



Opel of Vektra
+ 1.1. Controls and control devices
+ 2. Maintenance service
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Systems of start, ignition
+ 7. Transmission
- 8. Brake system
   8.1. Introduction
   8.2. Technical characteristics
   8.3. Prorolling of hydraulic brake system
   8.4. Brake pipelines and hoses
   8.5. Replacement of lobbies brake колодок
   8.6. Replacement back brake колодок on disk brakes
   8.7. Replacement back brake колодок on drum-type brakes
   8.8. Replacement brake колодок a manual brake
   8.9. Forward and back brake disks
   8.10. A forward brake disk
   8.11. A back brake disk
   8.12. A back brake drum
   8.13. A forward support
   8.14. A back support
   8.15. The back working brake cylinder
   8.16. The main brake cylinder
   8.17. A brake pedal
   8.18. The vacuum amplifier of brakes
   8.19. The unilateral valve of the vacuum amplifier of brakes
   8.20. Adjustment of a manual brake
   8.21. The lever of a manual brake
   8.22. A cable of a manual brake
   8.23. Antiblocking system of brakes (ABS)
   - 8.24. Elements of antiblocking system of brakes
      8.24.1. The hydraulic modulator and the electronic control device
      8.24.2. The gauge of rotation of a wheel
      8.24.3. The vacuum pump of cars with diesel engines
+ 9. A running gear
+ 10. A body
+ 11. An electric equipment
+ 12. The basic malfunctions


9fd37707

8.24. Elements of antiblocking system of brakes

8.24.1. The hydraulic modulator and the electronic control device

Removal

PERFORMANCE ORDER
1. Remove the accumulator.
2. Remove the block of the relay from the hydraulic modulator.
3. Uncover a tank of a brake liquid and, using a syringe, pump out all liquid from a tank.
4. Disconnect an electric socket from the top part of the hydraulic modulator.
5. Clear a dirt of junctions of brake tubes to the main brake cylinder. Enclose rags under places of connections to collect the flowed out brake liquid. Unscrew nuts of fastening of brake tubes to the main brake cylinder.
6. Unscrew three bolts and remove the hydraulic modulator and the management block upwards from a motor compartment.

Installation

PERFORMANCE ORDER

Installation is made in sequence, return to removal, but thus it is necessary to remove air from brake system.