Opel of Vektra
+ 1.1. Controls and control devices
+ 2. Maintenance service
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Systems of start, ignition
+ 7. Transmission
- 8. Brake system
8.1. Introduction
8.2. Technical characteristics
8.3. Prorolling of hydraulic brake system
8.4. Brake pipelines and hoses
8.5. Replacement of lobbies brake колодок
8.6. Replacement back brake колодок on disk brakes
8.7. Replacement back brake колодок on drum-type brakes
8.8. Replacement brake колодок a manual brake
8.9. Forward and back brake disks
8.10. A forward brake disk
8.11. A back brake disk
8.12. A back brake drum
8.13. A forward support
8.14. A back support
8.15. The back working brake cylinder
8.16. The main brake cylinder
8.17. A brake pedal
8.18. The vacuum amplifier of brakes
8.19. The unilateral valve of the vacuum amplifier of brakes
8.20. Adjustment of a manual brake
8.21. The lever of a manual brake
8.22. A cable of a manual brake
8.23. Antiblocking system of brakes (ABS)
+ 8.24. Elements of antiblocking system of brakes
+ 9. A running gear
+ 10. A body
+ 11. An electric equipment
+ 12. The basic malfunctions
|
Details of the back working brake cylinder
Removal
PERFORMANCE ORDER
|
1. Remove a brake drum. |
2. Using a clip, press a brake hose in a place closest to the working brake cylinder. |
3. Using flat-nose pliers, remove the top returnable spring compressing brake Pads. Remove the top ends brake колодок from pistons of the working brake cylinder. |
4. Remove a dirt round a junction of a brake hose and a back part of the working brake cylinder. Unscrew a connecting nut. Being careful, take a brake pipe from the working brake cylinder and close its stopper. |
5. Unscrew two bolts of fastening of the working brake cylinder to a brake board. Being careful, remove the working brake cylinder. |
|
Repair
PERFORMANCE ORDER
|
1. Clear a dust and a dirt from the working brake cylinder. |
2. Remove dustproof covers from each end of the cylinder. |
3. Take both pistons with sealing rings from the brake cylinder. |
4. Check up a condition of pistons and the brake cylinder on deterioration, corrosion and other defects. |
5. Establish sealing rings on the piston, grease with their pure brake liquid and establish pistons in the brake cylinder. |
6. Establish dustproof caps. |
|
Installation
PERFORMANCE ORDER
|
1. Wipe a brake board, establish the brake pipeline on the brake cylinder and screw up a connecting nut on two turns. |
2. Screw in bolts of fastening of the working brake cylinder. Definitively tighten a nut of fastening of the brake pipeline. |
3. Remove a clip from a brake hose. |
4. Establish brake Pads on pistons of the brake cylinder and establish the top returnable spring. |
5. Establish a brake drum. |
6. Remove air from brake system. |
|
|
|