Opel Vectra B

Since 1995 of release

Repair and car operation



Opel of Vektra
+ 1.1. Controls and control devices
+ 2. Maintenance service
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Systems of start, ignition
+ 7. Transmission
- 8. Brake system
   8.1. Introduction
   8.2. Technical characteristics
   8.3. Prorolling of hydraulic brake system
   8.4. Brake pipelines and hoses
   8.5. Replacement of lobbies brake колодок
   8.6. Replacement back brake колодок on disk brakes
   8.7. Replacement back brake колодок on drum-type brakes
   8.8. Replacement brake колодок a manual brake
   8.9. Forward and back brake disks
   8.10. A forward brake disk
   8.11. A back brake disk
   8.12. A back brake drum
   8.13. A forward support
   8.14. A back support
   8.15. The back working brake cylinder
   8.16. The main brake cylinder
   8.17. A brake pedal
   8.18. The vacuum amplifier of brakes
   8.19. The unilateral valve of the vacuum amplifier of brakes
   8.20. Adjustment of a manual brake
   8.21. The lever of a manual brake
   8.22. A cable of a manual brake
   8.23. Antiblocking system of brakes (ABS)
   + 8.24. Elements of antiblocking system of brakes
+ 9. A running gear
+ 10. A body
+ 11. An electric equipment
+ 12. The basic malfunctions


9fd37707

8.21. The lever of a manual brake

Removal

PERFORMANCE ORDER
1. Establish the car over a viewing hole.
2. Remove system of release of the fulfilled gases.
3. Unscrew the heat resisting screen for access to the jack of the lever of a manual brake. Lower the lever of a manual brake, push the jack forward and disconnect a forward cable of a manual brake.
4. In the car remove the central console and a protective casing of the lever of a manual brake.
5. Unscrew an adjusting nut from a forward part of a forward cable of a manual brake and remove a cable from the lever of a manual brake.
6. Unscrew nuts of fastening of the lever of a manual brake (arrow), disconnect an electric socket and take the lever from car salon.

Installation

PERFORMANCE ORDER
Installation is made in sequence, return to removal. Thus it is necessary to adjust a manual brake.