Opel Vectra B

Since 1995 of release

Repair and car operation



Opel of Vektra
+ 1.1. Controls and control devices
+ 2. Maintenance service
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Systems of start, ignition
+ 7. Transmission
- 8. Brake system
   8.1. Introduction
   8.2. Technical characteristics
   8.3. Prorolling of hydraulic brake system
   8.4. Brake pipelines and hoses
   8.5. Replacement of lobbies brake колодок
   8.6. Replacement back brake колодок on disk brakes
   8.7. Replacement back brake колодок on drum-type brakes
   8.8. Replacement brake колодок a manual brake
   8.9. Forward and back brake disks
   8.10. A forward brake disk
   8.11. A back brake disk
   8.12. A back brake drum
   8.13. A forward support
   8.14. A back support
   8.15. The back working brake cylinder
   8.16. The main brake cylinder
   8.17. A brake pedal
   8.18. The vacuum amplifier of brakes
   8.19. The unilateral valve of the vacuum amplifier of brakes
   8.20. Adjustment of a manual brake
   8.21. The lever of a manual brake
   8.22. A cable of a manual brake
   8.23. Antiblocking system of brakes (ABS)
   + 8.24. Elements of antiblocking system of brakes
+ 9. A running gear
+ 10. A body
+ 11. An electric equipment
+ 12. The basic malfunctions



8.6. Replacement back brake колодок on disk brakes
THE GENERAL DATA

The prevention

Necessarily make replacement of all колодок on one axis of the car even if deterioration borders were reached by one колодка. If Pads will be repeatedly established, before removal mark them.


PERFORMANCE ORDER
1. Lift a back part of the car and fix on supports. Remove back wheels.
2. Note an arrangement of a spring of an antitinkling sound, then, using a steel core or a screw-driver, from lateral aspect squeeze out the bottom and top pins of fastening brake колодок.
3. Remove an antijingle spring.
4. Using the special tool or flat-nose pliers, take external brake колодку from a support.
5. Using flat-nose pliers, take internal brake колодку from a support.
6. Clear a support of a dust and a dirt.
7. Measure a thickness brake колодок.
8. If Pads are suitable to the further operation, clear them, using a wire brush and rags.
9. If will be established new brake Pads, press the piston into a support the hammer handle. Thus watch, that the piston has not warped, and surfaces of the piston and dusterа have not been damaged. At вдвигании the piston the brake liquid is superseded from the brake cylinder in a broad tank. Therefore constantly observe of liquid level in a tank, and if necessary, pump out from a tank its small amount.
10. Check up that dredging in the piston are located at an angle 23 ° to a horizontal line. If necessary turn the piston in demanded position.
11. Establish new brake Pads in a support. Check up that Pads freely move in a support.
12. Establish an antitinkling sound spring on Pads, then from the inside insert pins of fastening brake колодок. Thus simultaneously press an antitinkling sound spring.
13. Some times press a brake pedal that brake Pads have nestled on a brake disk.
14. Repeat the actions set forth above on the second wheel.
15. Establish wheels and lower the car.
16. Check up level of a brake liquid.