Opel Vectra B

Since 1995 of release

Repair and car operation



Opel of Vektra
+ 1.1. Controls and control devices
+ 2. Maintenance service
+ 3. Engines
+ 4. Heating, ventilation
- 5. Fuel system
   + 5.1. Fuel system of petrol engines
   - 5.2. Fuel systems of the diesel engine
      5.2.1. Introduction
      5.2.2. Technical characteristics
      5.2.3. The air filter and air inlet channels
      5.2.4. An accelerator pedal
      5.2.5. Filling and prorolling of fuel system
      5.2.6. The gauge of level of fuel
      5.2.7. A fuel tank
      5.2.8. Check and adjustment of the maximum turns
      5.2.9. Start of the cold engine
      + 5.2.10. Electric knots of system of injection
      5.2.11. The fuel pump of a high pressure
      5.2.12. Check of the moment of injection of fuel
      5.2.13. Adjustment of the moment of injection of fuel
      5.2.14. Fuel atomizers
      5.2.15. Турбонагнетатель
      5.2.16. The heat exchanger
      5.2.17. An inlet collector
      5.2.18. A final collector
+ 6. Systems of start, ignition
+ 7. Transmission
+ 8. Brake system
+ 9. A running gear
+ 10. A body
+ 11. An electric equipment
+ 12. The basic malfunctions


влагостойкий мдф

5.2.5. Filling and prorolling of fuel system
THE GENERAL DATA

After any separation of fuel system air which is necessary for removing can get to it. In case of full development of fuel from a fuel tank it is not obligatory to fill in completely a fuel tank and to pump over fuel system. It is enough to add fuel in a fuel tank and to start the engine a starter at completely pressed pedal of an accelerator. After engine start slightly increase turns of idling for the termination of process of prorolling of fuel system.