Opel Vectra B

Since 1995 of release

Repair and car operation



Opel of Vektra
+ 1.1. Controls and control devices
+ 2. Maintenance service
+ 3. Engines
+ 4. Heating, ventilation
- 5. Fuel system
   + 5.1. Fuel system of petrol engines
   - 5.2. Fuel systems of the diesel engine
      5.2.1. Introduction
      5.2.2. Technical characteristics
      5.2.3. The air filter and air inlet channels
      5.2.4. An accelerator pedal
      5.2.5. Filling and prorolling of fuel system
      5.2.6. The gauge of level of fuel
      5.2.7. A fuel tank
      5.2.8. Check and adjustment of the maximum turns
      5.2.9. Start of the cold engine
      + 5.2.10. Electric knots of system of injection
      5.2.11. The fuel pump of a high pressure
      5.2.12. Check of the moment of injection of fuel
      5.2.13. Adjustment of the moment of injection of fuel
      5.2.14. Fuel atomizers
      5.2.15. Турбонагнетатель
      5.2.16. The heat exchanger
      5.2.17. An inlet collector
      5.2.18. A final collector
+ 6. Systems of start, ignition
+ 7. Transmission
+ 8. Brake system
+ 9. A running gear
+ 10. A body
+ 11. An electric equipment
+ 12. The basic malfunctions



5.2.3. The air filter and air inlet channels

Removal
PERFORMANCE ORDER
Engines of 1,7 l
1. Loosen the collars also remove the inlet channel from the case of the air filter.
2. Unscrew nuts, fastening the case of the air filter, disconnect the case from an air inlet and take it from a motor compartment.
Engines of 2,0 l
3. Remove a wire of weight from the accumulator and disconnect electric sockets from a measuring instrument of a stream of air and the gauge of temperature of arriving air (it is specified by an arrow).
4. Disconnect a ventilation hose картера from the inlet channel, ослабьте collars and remove the air channel together with a measuring instrument of a stream of air.
5. Uncover the air filter and take filtering element, marking its arrangement. Unscrew nuts and remove the case of the air filter.
6. On engines of a turbo of low pressure to remove tubes of giving of air, connecting турбонагнетатель and an inlet collector, unscrew screws and remove a plastic casing from the top part of the engine. Loosen the a collar of fastening of a pipe of giving of air to a collector.
7. Unscrew bolts (are specified by arrows), fastening a pipe of giving of air to a head cover, then disconnect a pipe of giving of air from турбонагнетателя. Remove a pipe of giving of air (a photo on the right).
8. Remove a sealing ring (it is specified by an arrow) which is established between a pipe and турбонагнетателем.
9. On engines of a turbo of a high pressure the pipes connecting the heat exchanger and a collector and pipes турбонагнетателя, can be to remove after easing of collars. For removal of a metal pipe ослабьте a clip also remove a pipe with турбонагнетателя. Remove a sealing ring which is established between a pipe and турбонагнетателем.

Installation

PERFORMANCE ORDER
Installation is made in sequence, to removal, thus it is necessary to replace with return a sealing ring on турбонагнетателе.