Opel of Vektra
+ 1.1. Controls and control devices
+ 2. Maintenance service
- 3. Engines
+ 3.1. Repair of engine SOCH established in the car
+ 3.2. Repair of engine DOSH established in the car
+ 3.3. Repair of the diesel engine of 1,7 l established in the car
- 3.4. Repair of the diesel engine of 2,0 l established in the car
3.4.1. Introduction
3.4.2. Technical characteristics
3.4.3. Check of pressure of compression
3.4.4. The top dead point (ВМТ) the piston of the first cylinder
3.4.5. Check and mechanism adjustment timing
3.4.6. A cover of a head of the block of cylinders
3.4.7. A pulley of a cranked shaft
3.4.8. A chain cover
3.4.9. Натяжители chains
3.4.10. Chains and asterisks
3.4.11. Camshafts and pushers
3.4.12. A head of the block of cylinders
3.4.13. The oil pallet
3.4.14. The oil pump
3.4.15. An oil radiator
3.4.16. Replacement of sealing rings of a cranked shaft
3.4.17. A flywheel
3.4.18. Suspension brackets of the power unit
+ 3.5. Major repairs of engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Systems of start, ignition
+ 7. Transmission
+ 8. Brake system
+ 9. A running gear
+ 10. A body
+ 11. An electric equipment
+ 12. The basic malfunctions
|
Removal
PERFORMANCE ORDER
|
1. Lift a forward part of the car and fix on supports. Remove the right wheel. |
2. Remove auxiliary приводной a belt. |
3. Loosen the a bolt of fastening of a pulley of a cranked shaft. For an exception проворачивания a cranked shaft fix it, having included any transfer and having pressed a brake. |
4. Unscrew a bolt and remove a pulley of a cranked shaft. Check up a condition of an oil sealing ring of a cranked shaft and, if necessary, replace it. |
|
Installation
The prevention
At pulley installation it is necessary to use a new bolt.
PERFORMANCE ORDER
|
|
1. Establish a pulley on a cranked shaft. Thus a groove in a pulley combine with шпонкой a cranked shaft. |
|
2. Establish a bolt of fastening of a pulley of a cranked shaft. |
|
3. Fix a cranked shaft from проворачивания and in stages tighten a bolt of fastening of a pulley of a cranked shaft. |
4. Establish auxiliary приводной a belt. |
5. Establish a wheel and lower the car. |
|
|
|