Opel Vectra B

Since 1995 of release

Repair and car operation



Opel of Vektra
+ 1.1. Controls and control devices
+ 2. Maintenance service
- 3. Engines
   + 3.1. Repair of engine SOCH established in the car
   + 3.2. Repair of engine DOSH established in the car
   + 3.3. Repair of the diesel engine of 1,7 l established in the car
   - 3.4. Repair of the diesel engine of 2,0 l established in the car
      3.4.1. Introduction
      3.4.2. Technical characteristics
      3.4.3. Check of pressure of compression
      3.4.4. The top dead point (ВМТ) the piston of the first cylinder
      3.4.5. Check and mechanism adjustment timing
      3.4.6. A cover of a head of the block of cylinders
      3.4.7. A pulley of a cranked shaft
      3.4.8. A chain cover
      3.4.9. Натяжители chains
      3.4.10. Chains and asterisks
      3.4.11. Camshafts and pushers
      3.4.12. A head of the block of cylinders
      3.4.13. The oil pallet
      3.4.14. The oil pump
      3.4.15. An oil radiator
      3.4.16. Replacement of sealing rings of a cranked shaft
      3.4.17. A flywheel
      3.4.18. Suspension brackets of the power unit
   + 3.5. Major repairs of engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Systems of start, ignition
+ 7. Transmission
+ 8. Brake system
+ 9. A running gear
+ 10. A body
+ 11. An electric equipment
+ 12. The basic malfunctions



3.4.6. A cover of a head of the block of cylinders

Removal

PERFORMANCE ORDER
1. Unscrew screws and remove a plastic protective casing from the top part of a cover of a head.
2. Loosen the a collar also disconnect a ventilation hose картера.
3. On turbo engines ослабьте a clip, крепящий a metal pipe to турбонагнетателю and a clip, крепящий the inlet channel to a collector. Unscrew two bolts and remove assemblage of a tubule from the engine together with ring consolidation which is established between a pipe and турбонагнетателем.
4. Now disconnect hoses of giving of fuel from the right end of a cover of a head and disconnect wires from candles накаливания. Unscrew a bolt, крепящий a plait of wires of an inlet collector to a head cover.
5. Unscrew bolts and uncover heads.

Installation

PERFORMANCE ORDER
1. Check up that interfaced surfaces of a cover of a head and a head of the block of cylinders, pure and dry. Establish a lining on a cover of a head of the block of cylinders.
2. Establish sealing washers under nests under bolts of fastening of a cover of a head.
3. Apply a thin film hermetic on a cylindrical surface on the left side of a cover of a head and a head of the block of cylinders (at the left – an arrangement of a layer of hermetic, on the right – places of drawing of hermetic).
4. Establish a cover of a head and tighten bolts of fastening by the demanded moment.
5. Connect hoses of giving of fuel and electric sockets and connect a ventilation hose картера.
6. On turbo models establish the inlet channel, using a new sealing ring.
7. Establish a protective plastic covering on a cover of a head and fix bolts.