Opel Vectra B

Since 1995 of release

Repair and car operation



Opel of Vektra
+ 1.1. Controls and control devices
+ 2. Maintenance service
- 3. Engines
   + 3.1. Repair of engine SOCH established in the car
   + 3.2. Repair of engine DOSH established in the car
   + 3.3. Repair of the diesel engine of 1,7 l established in the car
   - 3.4. Repair of the diesel engine of 2,0 l established in the car
      3.4.1. Introduction
      3.4.2. Technical characteristics
      3.4.3. Check of pressure of compression
      3.4.4. The top dead point (ВМТ) the piston of the first cylinder
      3.4.5. Check and mechanism adjustment timing
      3.4.6. A cover of a head of the block of cylinders
      3.4.7. A pulley of a cranked shaft
      3.4.8. A chain cover
      3.4.9. Натяжители chains
      3.4.10. Chains and asterisks
      3.4.11. Camshafts and pushers
      3.4.12. A head of the block of cylinders
      3.4.13. The oil pallet
      3.4.14. The oil pump
      3.4.15. An oil radiator
      3.4.16. Replacement of sealing rings of a cranked shaft
      3.4.17. A flywheel
      3.4.18. Suspension brackets of the power unit
   + 3.5. Major repairs of engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Systems of start, ignition
+ 7. Transmission
+ 8. Brake system
+ 9. A running gear
+ 10. A body
+ 11. An electric equipment
+ 12. The basic malfunctions



3.3.17. A flywheel

Removal

PERFORMANCE ORDER
1. Remove a transmission and coupling.
2. Fix a flywheel from проворачивания, having established a clamp on a gear wreath of a flywheel.
3. Put on a cranked shaft and a flywheel a combination label.
4. Unscrew bolts and remove a flywheel.

Check

PERFORMANCE ORDER
Check up a flywheel on deterioration from outside couplings and a condition of teeths of a gear wreath of a flywheel.

Installation


The prevention

At flywheel installation it is necessary to use new bolts.


PERFORMANCE ORDER
1. Clear interfaced surfaces of a flywheel and a cranked shaft.
2. Establish a flywheel according to earlier made labels and screw in new bolts of fastening of a flywheel.
3. Fix a flywheel from проворачивания and tighten in some stages bolts of fastening of a flywheel.
4. Establish coupling and a transmission.