Opel Vectra B

Since 1995 of release

Repair and car operation



Opel of Vektra
+ 1.1. Controls and control devices
+ 2. Maintenance service
- 3. Engines
   + 3.1. Repair of engine SOCH established in the car
   + 3.2. Repair of engine DOSH established in the car
   + 3.3. Repair of the diesel engine of 1,7 l established in the car
   - 3.4. Repair of the diesel engine of 2,0 l established in the car
      3.4.1. Introduction
      3.4.2. Technical characteristics
      3.4.3. Check of pressure of compression
      3.4.4. The top dead point (ВМТ) the piston of the first cylinder
      3.4.5. Check and mechanism adjustment timing
      3.4.6. A cover of a head of the block of cylinders
      3.4.7. A pulley of a cranked shaft
      3.4.8. A chain cover
      3.4.9. Натяжители chains
      3.4.10. Chains and asterisks
      3.4.11. Camshafts and pushers
      3.4.12. A head of the block of cylinders
      3.4.13. The oil pallet
      3.4.14. The oil pump
      3.4.15. An oil radiator
      3.4.16. Replacement of sealing rings of a cranked shaft
      3.4.17. A flywheel
      3.4.18. Suspension brackets of the power unit
   + 3.5. Major repairs of engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Systems of start, ignition
+ 7. Transmission
+ 8. Brake system
+ 9. A running gear
+ 10. A body
+ 11. An electric equipment
+ 12. The basic malfunctions



3.4.13. The oil pallet Removal

PERFORMANCE ORDER
1. Remove a wire of weight from the accumulator.
2. Lift a forward part of the car and fix on supports.
3. Merge engine oil. Establish a new washer on маслосливную a stopper and establish a stopper in the oil pallet, having tightened its demanded moment.
4. Disconnect electric sockets from gauges of temperature and oil level.
5. Unscrew bolts of fastening of a ledge of the oil pallet to картеру transmissions.
6. Gradually and consistently unscrew bolts of fastening of the oil pallet to the block of cylinders. Remove the oil pallet and a lining.
7. Unscrew bolts of fastening of a pipe маслоприемника and check up a condition of the mesh filter.

Installation

PERFORMANCE ORDER
1. Clear all traces of oil and a dirt from interfaced surfaces of the pallet and the block of cylinders.
2. Establish a new sealing ring on a pipe маслоприемника and establish a pipe into place.
3. Apply a thin film hermetic on the bottom surface of the block of cylinders interfaced to the oil pump and a back main cover of the bearing (places of drawing of hermetic are specified by arrows).
4. Establish a lining on the oil pallet and establish a lining on the block of cylinders. Fix the oil pallet bolts.
5. Working from the centre in diagonal sequence, tighten bolts of fastening of the oil pallet.
6. Screw up bolts of fastening of a ledge of the oil pallet to картеру transmissions.
7. Connect electric sockets to gauges of temperature and oil level.
8. Lower the car and fill in engine oil in the engine.