Opel of Vektra
+ 1.1. Controls and control devices
+ 2. Maintenance service
- 3. Engines
- 3.1. Repair of engine SOCH established in the car
3.1.1. Introduction
3.1.2. Technical characteristics
3.1.3. Check of pressure of compression
3.1.4. The top dead point (ВМТ) the piston of the first cylinder
3.1.5. A cover of a head of the block of cylinders
3.1.6. A pulley of a cranked shaft
3.1.7. Casings of a gear belt
3.1.8. A gear belt
3.1.9. The mechanism of a tension of a gear belt and pulleys
3.1.10. Replacement of a sealing ring of a cam-shaft
3.1.11. A cam-shaft and cam-shaft cases
3.1.12. Hydraulic pushers
3.1.13. A head of the block of cylinders
3.1.14. The oil pallet
3.1.15. The oil pump
3.1.16. The Flywheel / a drive plate
3.1.17. Replacement of sealing rings of a cranked shaft
3.1.18. A suspension bracket of the power unit
+ 3.2. Repair of engine DOSH established in the car
+ 3.3. Repair of the diesel engine of 1,7 l established in the car
+ 3.4. Repair of the diesel engine of 2,0 l established in the car
+ 3.5. Major repairs of engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Systems of start, ignition
+ 7. Transmission
+ 8. Brake system
+ 9. A running gear
+ 10. A body
+ 11. An electric equipment
+ 12. The basic malfunctions
|
THE TOP CASING
Removal
| PERFORMANCE ORDER
|
| 1. Remove a casing of the air filter. |
| 2. Remove auxiliary приводной a belt. |
|
3. Unscrew screws of fastening (arrow) of the top casing of a gear belt and remove it from the engine. |
|
Installation
Installation is made in sequence, return to removal.
THE BOTTOM CASING
Removal
| PERFORMANCE ORDER
|
| 1. Remove a pulley of a cranked shaft. |
|
2. Remove the top casing of a gear belt, unscrew screws of fastening (arrow) and remove the bottom casing of a gear belt. |
|
Installation
Installation is made in sequence, return to removal.
BACK CASING
Removal
| PERFORMANCE ORDER
|
| 1. Remove gear pulleys from distributive both cranked shaft and the mechanism of a tension of a gear belt. |
|
2. Unscrew bolts of fastening of a back casing and remove a casing. |
|
Installation
Installation is made in sequence, return to removal. |
|