Opel Vectra B

Since 1995 of release

Repair and car operation



Opel of Vektra
+ 1.1. Controls and control devices
+ 2. Maintenance service
- 3. Engines
   - 3.1. Repair of engine SOCH established in the car
      3.1.1. Introduction
      3.1.2. Technical characteristics
      3.1.3. Check of pressure of compression
      3.1.4. The top dead point (ВМТ) the piston of the first cylinder
      3.1.5. A cover of a head of the block of cylinders
      3.1.6. A pulley of a cranked shaft
      3.1.7. Casings of a gear belt
      3.1.8. A gear belt
      3.1.9. The mechanism of a tension of a gear belt and pulleys
      3.1.10. Replacement of a sealing ring of a cam-shaft
      3.1.11. A cam-shaft and cam-shaft cases
      3.1.12. Hydraulic pushers
      3.1.13. A head of the block of cylinders
      3.1.14. The oil pallet
      3.1.15. The oil pump
      3.1.16. The Flywheel / a drive plate
      3.1.17. Replacement of sealing rings of a cranked shaft
      3.1.18. A suspension bracket of the power unit
   + 3.2. Repair of engine DOSH established in the car
   + 3.3. Repair of the diesel engine of 1,7 l established in the car
   + 3.4. Repair of the diesel engine of 2,0 l established in the car
   + 3.5. Major repairs of engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Systems of start, ignition
+ 7. Transmission
+ 8. Brake system
+ 9. A running gear
+ 10. A body
+ 11. An electric equipment
+ 12. The basic malfunctions



3.1.6. A pulley of a cranked shaft
THE GENERAL DATA

The prevention

For fastening of a pulley of a cranked shaft it is necessary to use only a new bolt.


Removal

PERFORMANCE ORDER
1. Lift a forward part of the car and fix on supports. Remove the right forward wheel.
2. Remove auxiliary приводной a belt.
3. Loosen the a bolt of fastening of a pulley of a cranked shaft. For prevention of rotation of a cranked shaft on models with a mechanical transmission the assistant should include any transfer and press a brake. On models with an automatic transmission unscrew one of bolts of fastening of the hydrotransformer and, using a steel core, fix a drive plate to картеру transmissions.
4. Unscrew a bolt of fastening of a pulley of a cranked shaft and remove a pulley. Thus be careful not to damage the gauge of a cranked shaft.

Installation

PERFORMANCE ORDER
1. Establish a pulley of a cranked shaft (it is specified by an arrow) and fix its new bolt (is specified by an arrow).
2. Fix a cranked shaft from проворачивания the same method, as at easing of a bolt of fastening of a pulley of a cranked shaft.
3. Tighten a bolt of fastening of a pulley of a cranked shaft in three stages.