Opel Vectra B

Since 1995 of release

Repair and car operation



Opel of Vektra
+ 1.1. Controls and control devices
+ 2. Maintenance service
- 3. Engines
   - 3.1. Repair of engine SOCH established in the car
      3.1.1. Introduction
      3.1.2. Technical characteristics
      3.1.3. Check of pressure of compression
      3.1.4. The top dead point (ВМТ) the piston of the first cylinder
      3.1.5. A cover of a head of the block of cylinders
      3.1.6. A pulley of a cranked shaft
      3.1.7. Casings of a gear belt
      3.1.8. A gear belt
      3.1.9. The mechanism of a tension of a gear belt and pulleys
      3.1.10. Replacement of a sealing ring of a cam-shaft
      3.1.11. A cam-shaft and cam-shaft cases
      3.1.12. Hydraulic pushers
      3.1.13. A head of the block of cylinders
      3.1.14. The oil pallet
      3.1.15. The oil pump
      3.1.16. The Flywheel / a drive plate
      3.1.17. Replacement of sealing rings of a cranked shaft
      3.1.18. A suspension bracket of the power unit
   + 3.2. Repair of engine DOSH established in the car
   + 3.3. Repair of the diesel engine of 1,7 l established in the car
   + 3.4. Repair of the diesel engine of 2,0 l established in the car
   + 3.5. Major repairs of engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Systems of start, ignition
+ 7. Transmission
+ 8. Brake system
+ 9. A running gear
+ 10. A body
+ 11. An electric equipment
+ 12. The basic malfunctions


9fd37707

3.1.4. The top dead point (ВМТ) the piston of the first cylinder
THE GENERAL DATA

The top dead point (ВМТ) the piston is a point through which takes place each piston at проворачивании a cranked shaft. Each piston reaches positions ВМТ in the end of a compression step, then again in the end of an exhaust step. For the purpose of mechanism installation гозораспределения the engine it is used ВМТ the piston of the first cylinder.

PERFORMANCE ORDER
1. Check up that ignition is switched off. Remove high-voltage wires from spark plugs, then unscrew spark plugs.
2. For access to an adjusting label of a pulley of a camshaft remove the top casing of a gear belt.
3. Turn the engine a wrench for a pulley of a cranked shaft before combination of an adjusting label on a pulley of a camshaft with the index located on a back casing of a gear belt.
4. Thus the label on a pulley of a cranked shaft () should be combined with the index () on the bottom casing of a gear belt.