Opel Vectra B
Since 1995 of release
Repair and car operation
Opel
of Vektra
+
1.1. Controls and control devices
+
2. Maintenance service
-
3. Engines
-
3.1. Repair of engine SOCH established in the car
3.1.1. Introduction
3.1.2. Technical characteristics
3.1.3. Check of pressure of compression
3.1.4. The top dead point
(ВМТ) the
piston of the first cylinder
3.1.5. A cover of a head of the block of cylinders
3.1.6. A pulley of a cranked shaft
3.1.7. Casings of a gear belt
3.1.8. A gear belt
3.1.9. The mechanism of a tension of a gear belt and pulleys
3.1.10. Replacement of a sealing ring of a cam-shaft
3.1.11. A cam-shaft and cam-shaft cases
3.1.12. Hydraulic pushers
3.1.13. A head of the block of cylinders
3.1.14. The oil pallet
3.1.15. The oil pump
3.1.16. The Flywheel / a drive plate
3.1.17. Replacement of sealing rings of a cranked shaft
3.1.18. A suspension bracket of the power unit
+
3.2. Repair of engine DOSH established in the car
+
3.3. Repair of the diesel engine of 1,7 l established in the car
+
3.4. Repair of the diesel engine of 2,0 l established in the car
+
3.5. Major repairs of engines
+
4. Heating, ventilation
+
5. Fuel system
+
6. Systems of start, ignition
+
7. Transmission
+
8. Brake system
+
9. A running gear
+
10. A body
+
11. An electric equipment
+
12. The basic malfunctions
3.1.12. Hydraulic pushers
Removal
PERFORMANCE ORDER
1.
Remove the camshaft case.
2.
Remove levers
Pads
axial pressure.
3.
Remove
колодку
axial pressure.
4.
Remove hydraulic pushers and place all in the corresponding container so that at installation they became everyone on the place.
Check
PERFORMANCE ORDER
1.
Check up working surfaces of the bearing, a pusher, the valve which work in contact to camshaft cams.
2.
If defective, them it is necessary to replace hydraulic pushers, as their check is impossible.
Installation
PERFORMANCE ORDER
1.
Grease hydraulic pushers and nests in a head of the block of cylinders with pure engine oil. Establish hydraulic pushers on the places.
2.
Establish
Pads
axial pressure upon the top parts of corresponding valves.
3.
Grease levers with pure engine oil and establish them on the places. Then establish the camshaft case.