Opel Vectra B

Since 1995 of release

Repair and car operation



Opel of Vektra
+ 1.1. Controls and control devices
+ 2. Maintenance service
- 3. Engines
   - 3.1. Repair of engine SOCH established in the car
      3.1.1. Introduction
      3.1.2. Technical characteristics
      3.1.3. Check of pressure of compression
      3.1.4. The top dead point (ВМТ) the piston of the first cylinder
      3.1.5. A cover of a head of the block of cylinders
      3.1.6. A pulley of a cranked shaft
      3.1.7. Casings of a gear belt
      3.1.8. A gear belt
      3.1.9. The mechanism of a tension of a gear belt and pulleys
      3.1.10. Replacement of a sealing ring of a cam-shaft
      3.1.11. A cam-shaft and cam-shaft cases
      3.1.12. Hydraulic pushers
      3.1.13. A head of the block of cylinders
      3.1.14. The oil pallet
      3.1.15. The oil pump
      3.1.16. The Flywheel / a drive plate
      3.1.17. Replacement of sealing rings of a cranked shaft
      3.1.18. A suspension bracket of the power unit
   + 3.2. Repair of engine DOSH established in the car
   + 3.3. Repair of the diesel engine of 1,7 l established in the car
   + 3.4. Repair of the diesel engine of 2,0 l established in the car
   + 3.5. Major repairs of engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Systems of start, ignition
+ 7. Transmission
+ 8. Brake system
+ 9. A running gear
+ 10. A body
+ 11. An electric equipment
+ 12. The basic malfunctions



3.1.16. The Flywheel / a drive plate

Removal

PERFORMANCE ORDER
Mechanical transmission

The prevention

For flywheel fastening it is necessary to use only new bolts.


1. Remove a transmission. Remove couplings from a flywheel.
2. Fix a flywheel from проворачивания, having established a clamp on a gear wreath of a flywheel. Put combination labels on a flywheel and a cranked shaft.
3. Unscrew bolts of fastening and remove a flywheel.
Automatic transmission
4. Remove a transmission and a drive plate, noticing that there is the plate of preservation established between bolts of fastening and a plate of a drive.

Check

PERFORMANCE ORDER
1. On models with a mechanical transmission check up a flywheel on deterioration from outside couplings and a condition of teeths of a gear wreath.
2. On models with an automatic transmission check up a condition of a drive of the hydrotransformer and a gear wreath.

Installation

PERFORMANCE ORDER
Mechanical transmission
1. Clear interfaced surfaces of a flywheel and a cranked shaft.
2. Establish a flywheel according to earlier put labels and screw up fastening bolts.
3. Fix a flywheel from проворачивания.
4. Definitively tighten bolts of fastening of a flywheel.
5. Tighten bolts of fastening of a flywheel on a demanded corner.
6. Establish coupling and a transmission.
Automatic transmission
7. Clear interfaced surfaces of a plate of a drive and a cranked shaft.
8. Put on a carving of bolts of fastening of a plate of a drive the means interfering unscrewing of bolts, establish a drive plate according to early the made labels and screw up fastening bolts.
9. Establish a transmission.