Opel of Vektra
+ 1.1. Controls and control devices
+ 2. Maintenance service
+ 3. Engines
+ 4. Heating, ventilation
- 5. Fuel system
- 5.1. Fuel system of petrol engines
5.1.1. Introduction
5.1.2. Technical characteristics
5.1.3. The air filter and inlet channels
5.1.4. A control system in temperature of air submitted to the engine
5.1.5. An accelerator cable
5.1.6. An accelerator pedal
5.1.7. Fuel
+ 5.1.8. System of injection of fuel
5.1.9. Pressure removal in fuel system
5.1.10. The fuel pump
5.1.11. The gauge of level of fuel
5.1.12. A fuel tank
5.1.13. The throttle case
5.1.14. Check of system of injection of fuel
5.1.15. Elements of one-dot system of injection of fuel
+ 5.1.16. Elements of multidot system of injection of fuel
5.1.17. An inlet collector
5.1.18. A final collector
5.1.19. System of release of the fulfilled gases
+ 5.2. Fuel systems of the diesel engine
+ 6. Systems of start, ignition
+ 7. Transmission
+ 8. Brake system
+ 9. A running gear
+ 10. A body
+ 11. An electric equipment
+ 12. The basic malfunctions
|
Removal
| PERFORMANCE ORDER
|
|
|
1. In a motor compartment remove скобу fastenings of a cover of a cable of an accelerator and take a cable of an accelerator from a throttle cam. |
| |
2. Release an accelerator cable on all length from under fastening. On models with an automatic transmission it is necessary to disconnect an electric socket from the mechanism of inclusion of a hill-climbing gear which is established on an accelerator cable. |
| 3. In car salon unscrew clips and remove the bottom furnish of the panel from outside the driver for access to a pedal of management of fuel giving. |
| 4. Remove скобу fastenings and disconnect a cable of an accelerator from the top part of a pedal, management of fuel giving. |
| 5. In a motor compartment take from a partition a ring condensing a cable of an accelerator, and take an accelerator cable. |
|
Installation
| PERFORMANCE ORDER
|
| 1. From a motor compartment insert an accelerator cable into place and establish condensing ring of a cable of an accelerator on a partition of a motor compartment. |
| 2. Establish a cable cover in a clamp of a suspension bracket of a pedal, and an accelerator cable connect to a pedal of management of fuel giving. |
| 3. In a motor compartment check up that the cover of a cable of an accelerator is correctly placed in a condensing ring of a partition, then place a cable on all length in скобах fastenings. |
| 4. Connect a cable of an accelerator to a cam of a throttle and fix скобой. Establish a cable cover in an arm and adjust position of a cable of an accelerator. |
|
Adjustment
| PERFORMANCE ORDER
|
|
|
1. In a motor compartment remove a clip of fastening of a cover of a cable of an accelerator. |
| 2. Check up, that the throttle cam was in the starting position and, moving a cable cover, choose sagging of a cable of an accelerator. |
| 3. In the established position of a cable establish a fastening clip on external flutes of a cover of a cable before a rubber condensing ring and a washer. After clip and cable installation on the places insignificant sagging of a cable of an accelerator should be observed only. |
| 4. While the assistant smoothly presses an accelerator pedal, check up that the throttle cam completely turns and comes back in a starting position. |
|
|
|