Opel Vectra B

Since 1995 of release

Repair and car operation



Opel of Vektra
+ 1.1. Controls and control devices
+ 2. Maintenance service
+ 3. Engines
+ 4. Heating, ventilation
- 5. Fuel system
   - 5.1. Fuel system of petrol engines
      5.1.1. Introduction
      5.1.2. Technical characteristics
      5.1.3. The air filter and inlet channels
      5.1.4. A control system in temperature of air submitted to the engine
      5.1.5. An accelerator cable
      5.1.6. An accelerator pedal
      5.1.7. Fuel
      + 5.1.8. System of injection of fuel
      5.1.9. Pressure removal in fuel system
      5.1.10. The fuel pump
      5.1.11. The gauge of level of fuel
      5.1.12. A fuel tank
      5.1.13. The throttle case
      5.1.14. Check of system of injection of fuel
      5.1.15. Elements of one-dot system of injection of fuel
      + 5.1.16. Elements of multidot system of injection of fuel
      5.1.17. An inlet collector
      5.1.18. A final collector
      5.1.19. System of release of the fulfilled gases
   + 5.2. Fuel systems of the diesel engine
+ 6. Systems of start, ignition
+ 7. Transmission
+ 8. Brake system
+ 9. A running gear
+ 10. A body
+ 11. An electric equipment
+ 12. The basic malfunctions



5.1.18. A final collector

Removal and installation

PERFORMANCE ORDER
Engines SOCH of 1,6 l
1. Disconnect an electric socket from the oxygen gauge, located on gauge wires. Release electroconducting of the gauge from скоб fastenings so that the gauge could be removed together with a collector.
2. Remove a reception exhaust pipe.
3. Remove заборник the warmed-up air from a final collector.
4. Take probe measurements of level of engine oil and remove high-voltage wires from candles of 2nd and 3rd cylinders. Unscrew and remove the heat resisting screen of a final collector.
5. Unscrew nuts and remove a final collector from the engine together with a lining.
6. Installation is made in sequence, return to removal. Thus it is necessary to use a new lining of a final collector.
Other models
7. Remove the secondary pneumovalve of system of giving of air and a connecting branch pipe.
8. On l models 1,6 disconnect an electric socket of the gauge of the oxygen, located on wires, release electroconducting from скоб fastenings so that the gauge could be removed together with a collector.
9. Unscrew bolts of fastening of a reception exhaust pipe to a collector.
10. Unscrew nuts and remove a final collector together with a lining.
11. Installation is made in sequence, return to removal, thus it is necessary to establish new linings of a final collector and a reception exhaust pipe.