Opel of Vektra
+ 1.1. Controls and control devices
+ 2. Maintenance service
+ 3. Engines
+ 4. Heating, ventilation
- 5. Fuel system
- 5.1. Fuel system of petrol engines
5.1.1. Introduction
5.1.2. Technical characteristics
5.1.3. The air filter and inlet channels
5.1.4. A control system in temperature of air submitted to the engine
5.1.5. An accelerator cable
5.1.6. An accelerator pedal
5.1.7. Fuel
+ 5.1.8. System of injection of fuel
5.1.9. Pressure removal in fuel system
5.1.10. The fuel pump
5.1.11. The gauge of level of fuel
5.1.12. A fuel tank
5.1.13. The throttle case
5.1.14. Check of system of injection of fuel
5.1.15. Elements of one-dot system of injection of fuel
+ 5.1.16. Elements of multidot system of injection of fuel
5.1.17. An inlet collector
5.1.18. A final collector
5.1.19. System of release of the fulfilled gases
+ 5.2. Fuel systems of the diesel engine
+ 6. Systems of start, ignition
+ 7. Transmission
+ 8. Brake system
+ 9. A running gear
+ 10. A body
+ 11. An electric equipment
+ 12. The basic malfunctions
|
Removal of the inlet channel on models with engines of 1,8 and 2,0 l
|
|
On these models inlet channels fasten bolts. |
Removal
| PERFORMANCE ORDER
|
| 1. For removal of a casing of the air filter ослабьте скобы fastenings, disconnect the air channel, unscrew nuts and remove a casing from a motor compartment. |
| 2. On models with one-dot system of injection of fuel, disconnect a vacuum hose and an air inlet of the warmed-up air from a casing of the air filter. |
| 3. Tubes of the inlet channel can be separated and removed after removal скоб fastenings. In certain cases it is necessary to remove a ventilation hose картера the engine and electric sockets. Inlet channels also can fasten bolts. |
|
Installation
Installation is made in sequence, return to removal. |
|