Opel Vectra B

Since 1995 of release

Repair and car operation



Opel of Vektra
+ 1.1. Controls and control devices
+ 2. Maintenance service
+ 3. Engines
+ 4. Heating, ventilation
- 5. Fuel system
   - 5.1. Fuel system of petrol engines
      5.1.1. Introduction
      5.1.2. Technical characteristics
      5.1.3. The air filter and inlet channels
      5.1.4. A control system in temperature of air submitted to the engine
      5.1.5. An accelerator cable
      5.1.6. An accelerator pedal
      5.1.7. Fuel
      + 5.1.8. System of injection of fuel
      5.1.9. Pressure removal in fuel system
      5.1.10. The fuel pump
      5.1.11. The gauge of level of fuel
      5.1.12. A fuel tank
      5.1.13. The throttle case
      5.1.14. Check of system of injection of fuel
      5.1.15. Elements of one-dot system of injection of fuel
      + 5.1.16. Elements of multidot system of injection of fuel
      5.1.17. An inlet collector
      5.1.18. A final collector
      5.1.19. System of release of the fulfilled gases
   + 5.2. Fuel systems of the diesel engine
+ 6. Systems of start, ignition
+ 7. Transmission
+ 8. Brake system
+ 9. A running gear
+ 10. A body
+ 11. An electric equipment
+ 12. The basic malfunctions



5.1.10. The fuel pump

Removal

PERFORMANCE ORDER
1. Remove pressure in fuel system and remove a wire of weight from the accumulator.
2. Move a pillow of a back seat forward and raise a carpet covering over the fuel pump.
3. Using an edge of a thin screw-driver as the lever, remove a plastic cover for access to the fuel pump.
4. Disconnect an electric socket () from the fuel pump and paste its sticky tape to a body that it has not fallen for a fuel tank.
5. Press скобы, located with two parties of a clamp of a fuel hose, and remove fuel hoses ().
6. Unscrew a ring, крепящее a cover of the fuel pump. Raise it and from a cover underside disconnect an electric socket.
7. Loosen the collars, remove hoses and remove a cover of the fuel pump from car salon.
8. Release three скобы fastenings (1), pressing them inside by means of the special tool (2).
9. Lift a casing of the fuel pump from a fuel tank. Thus be careful not to drop the fuel filter established in the basis of the fuel pump.
10. Remove the fuel filter from the basis of the fuel pump. Check up a condition of the fuel filter and, if necessary, replace it.

Installation

Installation is made in sequence, return to removal.