Opel Vectra B

Since 1995 of release

Repair and car operation

Opel of Vektra
+ 1.1. Controls and control devices
+ 2. Maintenance service
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Systems of start, ignition
- 7. Transmission
   + 7.1. Coupling
   + 7.2. A mechanical transmission
   - 7.3. An automatic transmission
      7.3.1. Introduction
      7.3.2. Technical characteristics
      7.3.3. Oil replacement in a transmission
      7.3.4. Adjustment of the lever of the selector
      7.3.5. A selector cable
      7.3.6. The selector lever
      7.3.7. Replacement of a sealing ring of the hydrotransformer
      7.3.8. Electric elements of management of a transmission
      7.3.9. The switch of a manner of movement
      7.3.10. The electronic control device
      7.3.11. Gauges of an entrance and conducted shaft of a transmission
      7.3.12. The gauge of temperature of oil of a transmission
      7.3.13. Removal and transmission installation
      7.3.14. Transmission major repairs
   + 7.4. Power shafts
+ 8. Brake system
+ 9. A running gear
+ 10. A body
+ 11. An electric equipment
+ 12. The basic malfunctions

7.3.4. Adjustment of the lever of the selector

THE GENERAL DATA

The prevention
If accumulator switching-off is made with the selector lever in position Р, the lever will be fixed in this position.

PERFORMANCE ORDER

1. For clearing of the lever of fixing remove furnish of the lever of the selector and, using an edge of a thin screw-driver, press the clamp lever on the left forward party of the lever of the selector.

2. Move the selector lever to all positions and check up that the included transfer is correctly displayed on the indicator of position of the lever of the selector.

3. Establish the selector lever in River position

4. For access to a cable of a choice of transfers remove the accumulator and an accumulator support.

5. Take скобу blockings and release a cover of a cable of a choice of transfers from an arm on the top part of a transmission.

6. Check up that the lever of the selector (1) is established in position Р (2), then move the lever to all positions and establish it in a starting position. Fix a cover of a cable of the selector pressing скобы blockings before click.

7. Establish the accumulator and check up work of the lever of the selector.