Opel Vectra B

Since 1995 of release

Repair and car operation



Opel of Vektra
+ 1.1. Controls and control devices
+ 2. Maintenance service
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Systems of start, ignition
- 7. Transmission
   + 7.1. Coupling
   + 7.2. A mechanical transmission
   - 7.3. An automatic transmission
      7.3.1. Introduction
      7.3.2. Technical characteristics
      7.3.3. Oil replacement in a transmission
      7.3.4. Adjustment of the lever of the selector
      7.3.5. A selector cable
      7.3.6. The selector lever
      7.3.7. Replacement of a sealing ring of the hydrotransformer
      7.3.8. Electric elements of management of a transmission
      7.3.9. The switch of a manner of movement
      7.3.10. The electronic control device
      7.3.11. Gauges of an entrance and conducted shaft of a transmission
      7.3.12. The gauge of temperature of oil of a transmission
      7.3.13. Removal and transmission installation
      7.3.14. Transmission major repairs
   + 7.4. Power shafts
+ 8. Brake system
+ 9. A running gear
+ 10. A body
+ 11. An electric equipment
+ 12. The basic malfunctions



7.3.3. Oil replacement in a transmission
PERFORMANCE ORDER
1. Make a short trip for finishing of a transmission to working temperature.
2. Establish the car on the lift or over a viewing hole.
3. Take the index of level of oil, then establish the corresponding container under a drain stopper of a transmission. The drain stopper (1) is located from the back right party картера transmissions.
4. Unscrew a drain stopper and merge oil from a transmission.
5. Establish a sealing washer on a stopper and screw up a stopper into place.
6. Fill in oil in a transmission through a pipe of a measuring instrument of level of oil.
7. Start the engine in an idling mode for some minutes, switch off the engine and check up oil level in a transmission. If necessary add oil. Make control check and repeatedly check up oil level.