Opel of Vektra
+ 1.1. Controls and control devices
+ 2. Maintenance service
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Systems of start, ignition
- 7. Transmission
+ 7.1. Coupling
+ 7.2. A mechanical transmission
- 7.3. An automatic transmission
7.3.1. Introduction
7.3.2. Technical characteristics
7.3.3. Oil replacement in a transmission
7.3.4. Adjustment of the lever of the selector
7.3.5. A selector cable
7.3.6. The selector lever
7.3.7. Replacement of a sealing ring of the hydrotransformer
7.3.8. Electric elements of management of a transmission
7.3.9. The switch of a manner of movement
7.3.10. The electronic control device
7.3.11. Gauges of an entrance and conducted shaft of a transmission
7.3.12. The gauge of temperature of oil of a transmission
7.3.13. Removal and transmission installation
7.3.14. Transmission major repairs
+ 7.4. Power shafts
+ 8. Brake system
+ 9. A running gear
+ 10. A body
+ 11. An electric equipment
+ 12. The basic malfunctions
|
Arrangement of gauges of speed of an entrance shaft and conducted shaft
|
|
Gauges are located in the top part of a transmission. The gauge of speed of an entrance shaft is located more close by the left forward end of a transmission.
1. The gauge of speed of an entrance shaft
2. The gauge of speed of a conducted shaft |
Removal
| PERFORMANCE ORDER
|
| 1. For access to gauges remove the accumulator and an accumulator support. |
| 2. Disconnect an electric socket from gauges. |
| 3. Unscrew bolts and remove gauges. |
|
Installation
| PERFORMANCE ORDER
|
| Installation is made in sequence, return to removal. Thus on gauges it is necessary to establish new sealing rings. |
|
|
|