Opel Vectra B

Since 1995 of release

Repair and car operation

Opel of Vektra
- 1.1. Controls and control devices
   1.2. A combination of devices
   1.3. Control bulbs
   1.4. The counter of the passed way and hours
   1.5. The Triple-Info-display
   1.6. The Multi-Info-display
   1.7. The Multi-Info-display - Check-control
   1.8. The Multi-Info-display - the Onboard computer
   1.9. Heating and ventilation system
   1.10. The conditioner
   1.11. Heating
   1.12. The electronic climate control
   1.13. System TC
   1.14. Cruise-control
   1.15. The catalyst
   1.16. A signalling device of electronic system of the engine
   1.17. System of release of the fulfilled gases
   1.18. An automatic transmission
   1.19. Instructions on driving
   1.20. Economy of fuel
   1.21. A fuel grade
+ 2. Maintenance service
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Systems of start, ignition
+ 7. Transmission
+ 8. Brake system
+ 9. A running gear
+ 10. A body
+ 11. An electric equipment
+ 12. The basic malfunctions

1.5. The Triple-Info-display

THE GENERAL DATA

Indication of time, external temperature, and also a radio receiver or date.

At the included ignition time and external temperature are displayed, at the switched off radio receiver date is displayed.
Brightness of indication is regulated at the included illumination by means of the right regulator located under the switch of illumination.
At the switched off ignition indication of time, date and external temperature by short pressing of one of two buttons from above the display can be caused short-term, about 15 seconds.

Date and time installation

To switch off a radio receiver, and buttons over the display to press in a following order:

Installation mode:

About 2 seconds, days blink;
To establish day;
Months blink;
To establish month;
Years blink;
To establish year;
Hours blink;
To establish hours;
Minutes blink;
To establish minute;
Hours to within a second join.

If installation only is required to time in an installation mode to press the button until hours or will start to blink minutes.

Automatic installation of date and time

Automatic installation of date and time is possible during reception of broadcasts from radio stations with RDS radiating signal RDS.
Automatic installation is carried out after inclusion of a radio receiver and reception of signal RDS. Installation process is displayed on the display by means. If there is no reception of signal RDS or it poor-quality date and time should be established manually.
Deenergizing and inclusion of automatic installation (e.g. during poor-quality reception of signal RDS from radio station):

To hold pressed about 2 seconds, hours are translated in an installation mode;
To press two times (years will not start blinking yet);
To hold pressed about 3 seconds, will not start blinking yet on the display and not to appear an inscription „RDS TIME" (during it years blink);
To press, indication on the display:
RDS TIME 0 = off,
RDS TIME 1 = incl.;
To press three times.

External temperature

The going down temperature is displayed immediately, raising – with a delay.
For the prevention of an icing of road indication at temperature more low 3 °С on the display is deduced a symbol.