Opel Vectra B

Since 1995 of release

Repair and car operation



Opel of Vektra
+ 1.1. Controls and control devices
+ 2. Maintenance service
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Systems of start, ignition
- 7. Transmission
   - 7.1. Coupling
      7.1.1. Introduction
      7.1.2. Technical characteristics
      7.1.3. Removal of air from hydraulic system of coupling
      7.1.4. The main cylinder
      7.1.5. The working cylinder of coupling
      7.1.6. A coupling pedal
      7.1.7. Leading knot of coupling
   + 7.2. A mechanical transmission
   + 7.3. An automatic transmission
   + 7.4. Power shafts
+ 8. Brake system
+ 9. A running gear
+ 10. A body
+ 11. An electric equipment
+ 12. The basic malfunctions



7.1.4. The main cylinder

Removal

PERFORMANCE ORDER
1. For access improvement to the main cylinder of coupling remove the block of the relay from the top part of modulator ABS and move it aside. If necessary remove the vacuum amplifier of brakes.
2. To reduce loss of a brake liquid, uncover a nutritious tank, enclose sheet of polyethylene and reliably screw up a cover on a tank.
3. Loosen the a collar also remove a pipe of the main cylinder of coupling from a nutritious tank, close a pipe and the union of a nutritious tank stoppers.
4. In car salon unscrew clips and remove furnish of the bottom part of the panel of devices from outside the driver for access to a coupling pedal.
5. Release скобу fastenings and remove a hydraulic hose of the working cylinder of coupling from a working part of the main cylinder. Close a pipe and the channel of the main cylinder of coupling by stoppers.
6. In car salon remove скобу and take a pin, крепящий a pusher of the main cylinder to a coupling pedal.
7. In a motor compartment unscrew nuts and remove the main cylinder of coupling.

Installation

PERFORMANCE ORDER
1. Check up that an interfaced surface of the main cylinder of coupling and a partition of a motor compartment, pure and dry and establish a lining.
2. Establish the main cylinder of coupling so that the pusher collar was correctly combined with a coupling pedal. Screw up nuts of fastening of the main cylinder of coupling.
3. Grease a pin with universal greasing, combine a collar of a pusher and a pedal of coupling and establish a pin. Fix a pin lock скобой.
4. Connect a hose of the working cylinder of coupling to the main cylinder and fix it скобой fastenings.
5. Establish furnish of the bottom part of the panel of devices from outside the driver.
6. Connect a hose of the main cylinder to a nutritious tank and fix a collar.
7. Remove air from hydraulic system of coupling.