Opel Vectra B

Since 1995 of release

Repair and car operation

Opel of Vektra
+ 1.1. Controls and control devices
+ 2. Maintenance service
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Systems of start, ignition
- 7. Transmission
   - 7.1. Coupling
      7.1.1. Introduction
      7.1.2. Technical characteristics
      7.1.3. Removal of air from hydraulic system of coupling
      7.1.4. The main cylinder
      7.1.5. The working cylinder of coupling
      7.1.6. A coupling pedal
      7.1.7. Leading knot of coupling
   + 7.2. A mechanical transmission
   + 7.3. An automatic transmission
   + 7.4. Power shafts
+ 8. Brake system
+ 9. A running gear
+ 10. A body
+ 11. An electric equipment
+ 12. The basic malfunctions

7.1.3. Removal of air from hydraulic system of coupling

The screw of removal of air is screwed in in a hose which fastens on the top part of a transmission. On some models access to the screw is possible only from under the car.

Unscrew a cover of a nutritious tank and check up, that level of a brake liquid in a tank was up to standard of a label max. At air removal watch liquid presence in a tank, without supposing an exposure of its bottom as thus air again will get to system.

Remove a dustproof cap from the union of prorolling and put on it the pure transparent hose which other end is necessary for lowering in the capacity partially filled with a brake liquid.

Sharply press a coupling pedal some times with an interval 2–3 seconds Unscrew on a floor of a turn the prorolling union at the pressed pedal. Continuing to press a pedal, supersede a liquid being in system together with air through a hose in capacity. After the pedal will reach extreme forward position, and liquid replacement through a hose will stop, will screw the prorolling union home.

Repeat these operations, the air outlet from a hose will not stop yet.

Keeping a pedal in the pressed position, screw up the union against the stop and remove a hose.

Wipe the union of prorolling and establish a protective cap.