Opel Vectra B

Since 1995 of release

Repair and car operation



Opel of Vektra
+ 1.1. Controls and control devices
+ 2. Maintenance service
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Systems of start, ignition
- 7. Transmission
   + 7.1. Coupling
   - 7.2. A mechanical transmission
      7.2.2. Introduction
      7.2.2. Technical characteristics
      7.2.3. Oil replacement in a transmission
      7.2.4. Adjustment of the mechanism of a gear change
      7.2.5. The gear change mechanism
      7.2.6. Replacement of sealing rings
      7.2.7. The switch of a lantern of a backing
      7.2.8. Transmission removal
   + 7.3. An automatic transmission
   + 7.4. Power shafts
+ 8. Brake system
+ 9. A running gear
+ 10. A body
+ 11. An electric equipment
+ 12. The basic malfunctions



7.2.4. Adjustment of the mechanism of a gear change
THE GENERAL DATA

Arrangement of a pin of blocking of the mechanism of a choice of transfers

1. Pressing of a pin of blocking
2. After moving of the lever of a gear change the blocking pin should return to a starting position

Mechanism adjustment is made through tightening a bolt, which крепит a gear change rod to draught of management by a transmission. The bolt is located on a back part of a transmission before a partition of a motor compartment and on the majority of models is accessible from above.

PERFORMANCE ORDER
1. Loosen the tightening a bolt of a rod of a gear change, but do not unscrew completely.
2. In car salon remove a protective casing of the lever of a gear change. Fix the gear change lever, having inserted a steel core or a drill in diameter of 5 mm into an aperture located on the left forward party in the basis of the lever.
3. Fix the mechanism of a choice of transfers, pressing on подпружиненный the pin of blocking located on a cover of the mechanism of a choice of transfers (fig. the Arrangement of a pin of blocking of the mechanism of a choice of transfers see).
4. After fixing of the lever of a gear change and a transmission tighten tightening a bolt of a rod of a gear change in some stages.
5. Take a core of blocking from the lever of a gear change and check up action of the mechanism of a gear change, and the pin of blocking of the mechanism of a choice of transfers automatically should return to a starting position at moving of the lever of a gear change.