Opel Vectra B

Since 1995 of release

Repair and car operation



Opel of Vektra
+ 1.1. Controls and control devices
+ 2. Maintenance service
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Systems of start, ignition
- 7. Transmission
   + 7.1. Coupling
   + 7.2. A mechanical transmission
   + 7.3. An automatic transmission
   - 7.4. Power shafts
      7.4.1. Introduction
      7.4.2. Technical characteristics
      7.4.3. Removal and power shaft installation
      7.4.4. Replacement of hinges of a power shaft
      7.4.5. Replacement of covers of hinges of equal angular speeds
+ 8. Brake system
+ 9. A running gear
+ 10. A body
+ 11. An electric equipment
+ 12. The basic malfunctions



7.4.5. Replacement of covers of hinges of equal angular speeds
PERFORMANCE ORDER
1. Remove a power shaft. Remove from a power shaft the hinge of equal angular speeds. If replacement of two protective covers is necessary, remove from a power shaft only one hinge of equal angular speeds and гаситель крутильных fluctuations.
2. Remove collars of fastening of protective covers and shift a protective cover from a power shaft.
3. Clean old greasing from the hinge of equal angular speeds and fill the hinge with new greasing.
4. Establish a new protective cover on a power shaft so that the flange of a protective cover was established in power shaft flutes. The internal flange of a protective cover should be on distance of 135 mm from the power shaft end. If on приводном to a shaft is available two flutes, an internal flange of a protective cover it is necessary to establish on distance of 123 mm from the power shaft end.
5. Fill with fresh greasing the hinge of equal angular speeds.
6. Establish the hinge of equal angular speeds with a new lock ring on a power shaft. Thus the lock ring should be fixed accurately in a power shaft flute.
7. Establish a collar of fastening of a protective cover.
8. Establish a protective cover on the hinge of equal angular speeds, then let the air out from under a protective cover.
9. Fix a protective cover new collars.
10. Establish a power shaft in the car.