Opel Vectra B

Since 1995 of release

Repair and car operation

Opel of Vektra
+ 1.1. Controls and control devices
+ 2. Maintenance service
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Systems of start, ignition
+ 7. Transmission
+ 8. Brake system
+ 9. A running gear
+ 10. A body
+ 11. An electric equipment
- 12. The basic malfunctions
   12.1. The engine
   12.2. Cooling system
   12.3. Fuel system and system of release of the fulfilled gases
   12.4. Coupling
   12.5. A mechanical transmission
   12.6. An automatic transmission
   12.7. Power shafts
   12.8. Brake system
   12.9. A suspension bracket and a steering

12.6. An automatic transmission

Because the automatic transmission represents very difficult unit, for diagnostics of malfunctions and transmission service it is necessary to address on HUNDRED.

Oil leaks

The oil used in a transmission, usually dark colour. Therefore do not mix it with engine oil which can get on a transmission from the engine. For definition of leaks of oil clear a dirt with картера a transmission and adjoining areas and spend a control trip on small speed that oil was not transferred by air stream. Establish the car on a viewing hole and define a place of leak of oil. Leak can occur from three zones: маслосборника, pipes probeа measurements of level of oil and a zone of a supply of oil to the heat exchanger.

Oil of a transmission of brown colour also has жженый a smell:

– Low level of oil in a transmission.

Insufficiently accurate gear change:

– Incorrectly established or adjusted cable of a choice of transfers. Because of it following malfunctions can be observed:

– Engine start can be made in position not only "Р" or "N";
– The indicator specifies selector position not what is included actually;
– The car begins movement at installation of the lever of the selector in position "Р" or "N";
– An indistinct or chaotic gear change.

The mode of inclusion of a hill-climbing gear does not work by pressing against the stop gas pedals:

– Low level of oil in a transmission;
– Wrong adjustment of a cable of a choice of transfers.

The engine is not started irrespective of position of the lever of the selector or started in any position of the selector:

– The gauge of blocking of a starter is incorrectly adjusted;
– Wrong adjustment of a cable of a choice of transfers.