Opel Vectra B

Since 1995 of release

Repair and car operation


Opel of Vektra
+ 1.1. Controls and control devices
+ 2. Maintenance service
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
+ 6. Systems of start, ignition
+ 7. Transmission
- 8. Brake system
   8.1. Introduction
   8.2. Technical characteristics
   8.3. Prorolling of hydraulic brake system
   8.4. Brake pipelines and hoses
   8.5. Replacement of lobbies brake колодок
   8.6. Replacement back brake колодок on disk brakes
   8.7. Replacement back brake колодок on drum-type brakes
   8.8. Replacement brake колодок a manual brake
   8.9. Forward and back brake disks
   8.10. A forward brake disk
   8.11. A back brake disk
   8.12. A back brake drum
   8.13. A forward support
   8.14. A back support
   8.15. The back working brake cylinder
   8.16. The main brake cylinder
   8.17. A brake pedal
   8.18. The vacuum amplifier of brakes
   8.19. The unilateral valve of the vacuum amplifier of brakes
   8.20. Adjustment of a manual brake
   8.21. The lever of a manual brake
   8.22. A cable of a manual brake
   8.23. Antiblocking system of brakes (ABS)
   + 8.24. Elements of antiblocking system of brakes
+ 9. A running gear
+ 10. A body
+ 11. An electric equipment
+ 12. The basic malfunctions



8.9. Forward and back brake disks
THE GENERAL DATA

Arrangement of a wheel bolt with a thick washer opposite to the screw of fastening of a brake disk () for fastening of a brake disk

The minimum thickness of a brake disk

The minimum thickness of a brake disk is beaten out on an external surface of a brake disk.

Check

PERFORMANCE ORDER
1. Lift accordingly a forward or back part of the car and fix on supports. Remove a corresponding wheel.
2. Establish on a bolt of fastening of a wheel a washer in the thickness of 10 mm and screw in a fastening bolt in an aperture located from an opposite side of screws of fastening of a brake disk.
3. Slowly turn a brake disk so that it could be considered from two parties. Deterioration of a brake disk from колодок should be in admissible limits. If deterioration exceeds an admissible limit, or there are cracks on a disk, the disk is subject to replacement.
4. The indicator of hour type check up palpation of a brake disk. The indicator of hour type fix in any convenient place and, turning a disk, define its palpation on distance of 10 mm from external edge.