Opel Vectra B

Since 1995 of release

Repair and car operation

Opel of Vektra
+ 1.1. Controls and control devices
+ 2. Maintenance service
+ 3. Engines
+ 4. Heating, ventilation
+ 5. Fuel system
- 6. Systems of start, ignition
   + 6.1. Gymnastics system
   - 6.2. Start system
      6.2.1. Introduction
      6.2.2. Technical characteristics
      6.2.3. A starter
      6.2.4. The gauge of pressure of oil
      6.2.5. The gauge of level of oil
   + 6.3. Ignition system
   + 6.4. System of prestarting heating of diesel engines
+ 7. Transmission
+ 8. Brake system
+ 9. A running gear
+ 10. A body
+ 11. An electric equipment
+ 12. The basic malfunctions

6.2.3. A starter
Removal

PERFORMANCE ORDER

1. Remove a wire of weight from the accumulator. Lift a forward part of the car and fix on supports. Remove an engine mudguard.

The petrol engine of 1,6 l

2. Unscrew two nuts and remove wires from contacts of the traction relay.

3. Unscrew a nut and remove the tyre of grounding from the top bolt of a starter.

4. Unscrew bolts of fastening and take a starter from under the car.

Petrol engines of 1,8 and 2,0 l

5. Unscrew bolts and remove an arm of support of an inlet collector.

6. Unscrew two nuts and remove wires from contacts of the traction relay.

7. Unscrew bolts and take a starter from the bottom part of a motor compartment.

The diesel engine of 1,7 l

8. Unscrew two nuts and remove wires from contacts of the traction relay.

9. Unscrew bolts and take a starter from the bottom part of a motor compartment.

The diesel engine of 2,0 l

10. For access improvement to a starter remove a reception exhaust pipe.

11. Unscrew bolts and remove the heat resisting screen of a starter.

12. Unscrew bolts and remove an arm of support of an inlet collector.

13. Unscrew two nuts and disconnect wires from contacts of the traction relay.

14. Unscrew nuts and bolts and remove an arm of support of a back part of a starter.

15. Unscrew bolts of fastening and take a starter from the bottom part of a motor compartment.

Installation

Installation is made in sequence, return to removal.